Service and Maintenance
- Injection molding, blow molding, extruders
- Thermoforming and rubber vulcanization
- Linear robots and tending manipulators
- Machine tools (except immersion and wire erosion)
- Presses, shears and other machinery for transformation
- Lathes, spindle automatics and semi-automatics
- Drying, dosing, conveying systems and mills
- Temperature control units and hot runner temperature controller
- Winding and feeding devices
- Bag making machines and equipment (PE bags)
- Candle making machinery
- Packaging, dosing and other dedicated machines
- Experience from other industrial sectors (joinery, knitting, winding machines)
- Fosca Process srl (ex. Dipre)
- Machinery of SIPA GmbH agents (www.sipa.si)
Tip
The procedure to repair a machine namely its process control system consists of a diagnosis of the situation, elimination of the defect (e.g. replacement of a switch) and the detection of the primary cause of the error (e.g. the occurrence of an excessive load). The last is often absent in the repair processes, which can then lead to failure and stoppage once again.